Amplificador P150vdg Rf Para Multiacopladores 150-160 Mhz
Marca:
Política de seguridad (editar con el módulo Información de seguridad y confianza para el cliente)
Política de envío (editar con el módulo Información de seguridad y confianza para el cliente)
Política de devolución (editar con el módulo Información de seguridad y confianza para el cliente)
Specific References
16 other products in the same category:
150W Polycrystalline Solar...
High Quality Modules
Encapsulated in transparent EVA and 4mm tempered glass. The back of the module is protected with a UV resistant TEDLAR sheet. The laminates are mounted on an anodized aluminum frame, ensuring maximum protection
TK2000 VHF Radio
Featured Features
- Frequency Range: 440-470 MHz
- 16 channels
- 4 watts output power
- Internal VOX function with 10 levels
- QT / DQT signaling
- Supplied with KRA-27M Antenna, KNB-63L Li-Ion Battery and KSC 35SE Quick Charger
- Supplied with KRA-27M antenna, KNB-63L Li-Ion battery and KSC-35SE quick charger
- Note - it does not include any encryption function, being ideal for use on networks where encryption is prohibited
Battery For Motorola...
Specifications:
- Capacity: 1620mAH. Battery
- Type: Lithium.
- Voltage: 7.4 V.
- Color: Black
- 100% brand new
- Suitable for: Motorola PRO5150
Battery For Motorola...
Specifications:
- Capacity: 1700mAH. Battery
- Type: lithium ion battery.
- Voltage: 7.4 V.
- Color: Black
- 100% brand new
- Suitable for: DGP series
12V to 120V Inverter 2000w...
This high efficiency DC-AC inverter converts 12 Volts DC to 2000 Watts of pure sine-wave AC power at 120 Volts, 60 Hz. Features include overload protection, low battery alarm / shut down, low idle power draw of less than 1 Amp. AC power is available from a NEMA-20R GFCI duplex outlet on the front panel. Safety certified to UL standards.
Battery charger 12V x 50A
This advanced fully automatic three-stage 50 Amp battery charger is ideal for charging all types of 12 Volt lead-acid batteries ( Flooded / Absorbed Glass Mat (AGM) / Gel Cell) from a 120 V, 60 Hz or 230 V, 50 Hz AC source. By means of a DIP switch setting, conversion to a two-stage algorithm is possible to charge batteries connected to a DC load (DC UPS). The unit can also be used as a DC Power Supply. Features include overload, short-circuit and over-temperature protection. The unit allows charging of up-to 2 separate battery banks.
MPPT Solar Charge Controller
- Brand: Sestecom C.A.
- Model: MPPT-40A - MPPT-60A
- Battery Voltage: 12v / 24v / 36v / 48v
- PV Max vol: 150VDC
- Max. Power: 520w 12v / 1040w 24v / 1560w 36v / 2080w 48v
- Max Cur: 40A (MPPT-40A) o 60A (MPPT-60A)