Featured Features

• Frequency Range: 440-470 MHz
• 16 channels
• 4 watts output power
• Internal VOX function with 10 levels
• QT / DQT signaling
• Supplied with KRA-27M Antenna, KNB-63L Li-Ion Battery and KSC 35SE Quick Charger
• Supplied with KRA-27M antenna, KNB-63L Li-Ion battery and KSC-35SE quick charger
• Note - it does not include any encryption function, being ideal for use on networks where encryption is prohibited

This high efficiency DC-AC inverter converts 12 Volts DC to 2000 Watts of pure sine-wave AC power at 120 Volts, 60 Hz. Features include overload protection, low battery alarm / shut down, low idle power draw of less than 1 Amp. AC power is available from a NEMA-20R GFCI duplex outlet on the front panel. Safety certified to UL standards.

CABLE THW 12AWG 7 Wires

•      100% COPPER,
•      BRAND: Cabel

High Quality Modules

Encapsulated in transparent EVA and 4mm tempered glass. The back of the module is protected with a UV resistant TEDLAR sheet. The laminates are mounted on an anodized aluminum frame, ensuring maximum protection

Key Features

• Frequency Range: 136-174 MHz
• 128 Channels/128 Zones
• 25 Watts RF Output
• Emergency Mode
• QT & DQT Signalling plus DTMF PTT ID
• 5-Tone Encode/Decode
• Electronic Serial Number
• MDC-1200 Signalling (requires special license ID)
• D-Sub 15 pin Interface Connector
• Requires Optional Microphone

Specifications:

• Capacity: 1450mAH. Battery
• Type: NI-MH.
• Voltage: 7.2 V.
• Color: Black
• 100% brand new
• Suitable for: Gp/pro5150/7550 Series

Stay connected to your workers, whether they're delivering cargo, dispatching trucks, or driving a school bus. The DEM 300 MOTOTRBO mobile radio offers you a reliable and cost-effective solution to keep your team in touch so they can communicate, coordinate and collaborate for maximum efficiency and safety. The DEM 300 is designed for the everyday driver, so you can connect without distraction.

This advanced fully automatic three-stage 30 Amp battery charger is ideal for charging all types of 12 Volt lead-acid batteries ( Flooded / Absorbed Glass Mat (AGM) / Gel Cell) from a 120 VAC, 50/60 Hz (default) or 230 VAC, 50/60 Hz (internal jumper setting) AC source. By means of a DIP switch setting, conversion to a two-stage algorithm is possible to charge batteries connected to a DC load (DC UPS). The unit can also be used as a DC Power Supply. Features include overload, short-circuit and over-temperature protection. The unit allows charging of up-to 3 separate battery banks.