Key Features

• Frequency Range: 400-470 MHz
• 128 Channels/128 Zones
• 25 Watts RF Output
• Emergency Mode
• QT & DQT Signalling plus DTMF PTT ID
• 5-Tone Encode/Decode
• Electronic Serial Number
• MDC-1200 Signalling (requires special license ID)
• D-Sub 15 pin Interface Connector
• Requires Optional Microphone

• Max Continuos Power 400W
• Peak Load Power Rate up to 800W
• For use with 12V System
• No Load Current Draw (Typical) 0.7A
• Waveform Modified Sine Wave
• Input DC Voltage Range 11V to 15V
• Usb Output 5V x 2A

The LiteBeam®is the latest evolution of a lightweight and compact, outdoor wireless broadband product from Ubiquiti Networks. Each of these models was designed to be an affordable cost/performance solution for long-distance, wireless broadband bridging. It operates in the worldwide, license-free 5 GHz frequency range with high-performance speeds.The LiteBeam combines proprietary hardware and software technologies to deliver its breakthrough combination of throughput and range with cost-effective value. The InnerFeed® technology integrates the entire radio system into the antenna feed, and our revolutionary airMAX TDMA protocol enhances network performance and scalability.

Featured Features

• Frequency range: 136-174 MHz
• Output power 5 watts
• 128 Channels / 128 Zones
• Voice Encryptor Included
• QT, DQT, DTMF and 5-Tone Signaling
• FleetSync digital signage, PTT ID and Selective Calling
• MDC-1200 signaling
• PC programming

Baofeng Bf-H5 Dual Band High Power Portable Dual Display Transceiver 10W Two Way Radio Walkie Talkie

Cable UTP Cat-6

• 100% COPPER,
• BRAND: ELECON
• BLUE COLOR FOR OUTDOORS
• APPLICATIONS: INTERNET, SECURITY CAMERAS, ETC

The Baofeng / Pofung UV-6 is a portable, powerful (5W), and multifunctional radio. It operates in dual band (VHF / UHF), to perform optimally both in places with obstacles (UHF recommended), and in open places (VHF recommended). Programmable device exclusively via USB cable.

This advanced fully automatic three-stage 50 Amp battery charger is ideal for charging all types of 12 Volt lead-acid batteries ( Flooded / Absorbed Glass Mat (AGM) / Gel Cell) from a 120 V, 60 Hz or 230 V, 50 Hz AC source. By means of a DIP switch setting, conversion to a two-stage algorithm is possible to charge batteries connected to a DC load (DC UPS). The unit can also be used as a DC Power Supply. Features include overload, short-circuit and over-temperature protection. The unit allows charging of up-to 2 separate battery banks.