• 10amp, 12amp overload
• convert 117v from C.A to 13.8 C.D
• low ripple
• internal protection for overload

• Max Continuos Power 400W
• Peak Load Power Rate up to 800W
• For use with 12V System
• No Load Current Draw (Typical) 0.7A
• Waveform Modified Sine Wave
• Input DC Voltage Range 11V to 15V
• Usb Output 5V x 2A

Main Features
DMR Digital Radio
Tier 2 time slots
Crystal Clear Call Quality
Dual Band Repeater
VHF/UHF 136-174/400-470Mhz
2200mAh High Capacity Battery
High Power/Low power(5W/1W)
4000Channels
≥3km of Range
21CM Dual Band Antenna
8-Level Stepped Frequency Selection
Auto power saving function,Super-Long Standby
14 hours usage time,up to 30 hours of standby time
Emergency Alarm
Flashlight
Individual/Group/All Call
Walkie-Talkie Detection
CTCSS/DCS
Compatible with Digital And Analog Systems

CABLE THW 4AWG 7 Wires

•      100% COPPER,
•      BRAND: Elecon

• Max Continuos Power 200W
• Peak Load Power Rate up to 400W
• For use with 12V System
• No Load Current Draw (Typical) 0.4A
• Waveform Modified Sine Wave
• Input DC Voltage Range 11V to 15V
• Usb Output 5V x 2A

Cable UTP Cat-5e

• 100% COPPER,
• BRAND: ELECON
• BLACK COLOR FOR OUTDOORS
• APPLICATIONS: INTERNET, SECURITY CAMERAS, ETC

This advanced fully automatic three-stage 50 Amp battery charger is ideal for charging all types of 12 Volt lead-acid batteries ( Flooded / Absorbed Glass Mat (AGM) / Gel Cell) from a 120 V, 60 Hz or 230 V, 50 Hz AC source. By means of a DIP switch setting, conversion to a two-stage algorithm is possible to charge batteries connected to a DC load (DC UPS). The unit can also be used as a DC Power Supply. Features include overload, short-circuit and over-temperature protection. The unit allows charging of up-to 2 separate battery banks.

This advanced fully automatic three-stage 15 Amp battery charger is ideal for charging all types of 12 Volt lead-acid batteries ( Flooded / Absorbed Glass Mat (AGM) / Gel Cell) from a 120 VAC, 50/60 Hz (default) or 230 VAC, 50/60 Hz (internal jumper setting) AC source. By means of a DIP switch setting, conversion to a two-stage algorithm is possible to charge batteries connected to a DC load (DC UPS). The unit can also be used as a DC Power Supply. Features include overload and short-circuit protection. The unit allows charging of up-to 3 separate battery banks.