• Max Continuos Power 1000W
• Peak Load Power Rate up to 2000W
• For use with 12V System
• No Load Current Draw (Typical) 0.4A
• Waveform Modified Sine Wave
• Input DC Voltage Range 11V to 15V
• Usb Output 5V x 2A

CABLE ATHW 10AWG 1 Wire

•      100% COPPER,
•      BRAND: Elecon

Specifications:

• Capacity: 2000mAH. Battery
• Type: NI-MH.
• Voltage: 7.2 V.
• Color: Black
• 100% brand new
• Suitable for: Gp/pro5150/7550 Series

This advanced fully automatic three-stage 30 Amp battery charger is ideal for charging all types of 12 Volt lead-acid batteries ( Flooded / Absorbed Glass Mat (AGM) / Gel Cell) from a 120 VAC, 50/60 Hz (default) or 230 VAC, 50/60 Hz (internal jumper setting) AC source. By means of a DIP switch setting, conversion to a two-stage algorithm is possible to charge batteries connected to a DC load (DC UPS). The unit can also be used as a DC Power Supply. Features include overload, short-circuit and over-temperature protection. The unit allows charging of up-to 3 separate battery banks.

Key Features

• Frequency Range: 136-174 MHz
• 128 Channels/128 Zones
• 25 Watts RF Output
• Emergency Mode
• QT & DQT Signalling plus DTMF PTT ID
• 5-Tone Encode/Decode
• Electronic Serial Number
• MDC-1200 Signalling (requires special license ID)
• D-Sub 15 pin Interface Connector
• Requires Optional Microphone

CABLE THW 12AWG 7 Wires

•      100% COPPER,
•      BRAND: Cabel

This high efficiency DC-AC inverter converts 12 Volts DC to 1000 Watts of pure sine-wave AC power at 120 Volts, 60 Hz. Features include built-in electronic GFCI, overload protection, low battery alarm / shut down, low idle power draw. AC power is available from a NEMA-20R GFCI duplex outlet on the front panel. Safety certified to UL standards.

Up to 500 m ² of Wi-Fi coverage

The MW325R creates an expansive wireless network that is capable of covering your home with up to 500m2 of wireless coverage. You can enjoy reliable, high-performance connections in your living room, bedroom, or even your backyard.

* Range specifications are based on performance test results. Actual performance varies based on application and environmental conditions.